Early prototype model showing air ducted from underneath kitchen
500px x 375px | 91.60kB

[source page]

acscompact eng png
503px x 500px | 165.00kB

[source page]

Lighting products Medical portable equipment Laser cooling systems

kampa 25 litre Thermo Electric Cooler 23222
473px x 383px | 33.80kB

[source page]

Enlarge this image 34 99

attachment php attachmentid=10​982 stc=1
480px x 640px | 59.50kB

[source page]

That thing can get your card under 0 degrees

kstudy2397206 0002 jpg
935px x 661px | 87.90kB

[source page]

Peliter113 jpg
415px x 500px | 76.30kB

[source page]

coolit elite forums jpg
364px x 550px | 44.30kB

[source page]

on We re going to pit one of the pre eminent thermoelectric cooling solutions the CoolIT Freezone Elite straight up against a custom water cooling kit both on a juiced up Quad Core CPU Click HERE for more

1 jpg
620px x 827px | 75.60kB

[source page]

cooling unit jpg
443px x 591px | 88.10kB

[source page]

thermoelectric coolers peltier coolers
374px x 560px | 42.70kB

[source page]

RAD STACK jpg
338px x 640px | 66.10kB

[source page]

using two MCR320 This will solve the tubing connectiong problem MCR220 is the old 3 8 NPT fitting so I have to used a special fitting adapters 3 8 to 1 4 bushing not shown 90 elbow

coldplate jpg
480px x 640px | 126.80kB

[source page]

Not bad with few minutes of lapping Die electric grease applied to the CPU socket

adapter dryfit jpg
394px x 640px | 84.40kB

[source page]

Day Three 13th April Custom rad shroud extender is dried and dry fitting to the TJ09 Koolance fan shroud will sit on top of the extend adapter and everything will fasten to the case

adapter 38to14 jpg
480px x 640px | 137.40kB

[source page]

and weld them seal just like the Swiftech stackable radiator There you go guys go do some rad modding

SINGLE LOAD22C INTEL jpg
609px x 816px | 386.10kB

[source page]

Note The TDP jumped up to 147w at stress load according to Cooltest he said the sensor is not accurate However I did use SiSoft Sandra for thermal power benching the software

Nextreme eTEG UPF40 Hi Res jpg
467px x 700px | 99.30kB

[source page]

eTEG UPF40 Power Generator hi res | low res

shroud adp05 jpg
398px x 640px | 56.10kB

[source page]

the second rad will be sandwiched right below the first rad and connected by 3 more fans This config will have 6 fans total pull push Now it need couple coats of primer and give it a black paint to match the Koolance shroud

463330 bytes
391px x 600px | 150.40kB

[source page]

24V PSU 437 watt pelt and dominator PRO water block 320 Watt 12 Volt Peltier with bare leads Only short term use a couple years ago Copper block attached and foam insulation around edge